Electronics ii and lab mosfets

 

Electronics II and Lab

 

MOSFETs

 

INTRODUCTION

 

Discuss the basic differences between JFETs and MOSFETs.

 

Why should MOSFETs be handles with special care?

 

EQUIPMENT

 

  • 1 power supply: 15V
  • 2 transistors: MTP10N05E/MC, IRF510
  • 1 resistor: 470Ω
  • 1 potentiometer 500kΩ
  • 1 diode: red LED
  • <List meters used>

 

PROCEDURE

 

Using Multisim construct the circuits shown below:

 

 

 

  1. Set the potentiometer to 0% then measure and record VGS,ID,VD.
  2. Set the value to 45% and take the three measurements.
  3. Increase the potentiometer until the LED turns off, record the readings.
  4. Replace the transistor with the IRF510 and repeat steps a) through c).

 

RESULTS

 

 

MTP10N05E/MC

IRF510

 

VGS

VD

ID

VGS

VD

ID

0%

 

 

 

 

 

 

45%

 

 

 

 

 

 

LED off

 

 

 

 

 

 

 

Discuss the results.

 

What types of applications can this circuit be used in? Explain.

 

CONCLUSION

 

What did you learn?

 

 

 

"We Offer Paper Writing Services on all Disciplines, Make an Order Now and we will be Glad to Help"